Furman M-8S Power Sequencer

6.000.000₫
VND USD

The Merit M-8S from Furman is an AC power sequencing solution for your rack mount system.


"Sản phẩm Furman M-8S Power Sequencer đang còn hàng và sẵn sàng gửi vận chuyển"


The Merit M-8S from Furman is an AC power sequencing solution for your rack mount system. Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load. There is also an additional unswitched single outlet on the front of the unit for convenience.

Features:
  • Standard level AC protection and filtering
  • Six configurable delayed rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet
  • Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only)
  • All settings and configurations available on rear panel
  • 15 amp rating
Maximum Output Current 15 amps, 120 VAC (thermal breaker)
Line Cord 14 AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
AC Receptacles Convenience Outlet (Front Panel): 1 un-switched NEMA 15-5R

 

Rear Panel Outlets: 2 un-switched NEMA 5-15R (1 duplex)

6 Sequenced Outlets: NEMA 5-15R (3 duplexes, each controlled by separate relay)

 

AC Surge Protection Merit class (sacrificial)
Protection Modes Line to neutral, zero ground leakage (spike protection)
Operating Voltage 130 V RMS (max continuous)
Max Clamp Voltage 500 V peak
Peak Impulse Current 12,000 amps
Energy Rating 225 joules
Filtering Standard level Pi LCR filter (AC)
Noise Attenuation > 26 dB, 100 kHz to 1 MHz
Operating Temperature Range 5 C (40 F) to 40º C (105º F)
Humidity Range < 90% rH (relative humidity)
Switch Front panel, sequence (ON, OFF)
Circuit Breaker Front panel, push to reset (thermal)
Front Panel Indicators Delay 1, delay 2, delay 3, power, protection OK
Dip Switches 12V Mode on/off, GND mode on, momentary/maintained (rear panel)
Potentiometer Rear panel, time calibration fine tune delay adjust
Remote Terminal +5-30 VDC In, 12 VDC (12 mA) out

 

Phoenix type 4-pin connector with screw terminals; +12V, STAT, REM, GND (class 2 wiring)

Dimensions 19.00 x 8.75 x 1.75" (482.60 x 222.30 x 44.50 mm)
Weight 7.00 lb (3.18 kg)

 

Packaging Info
Package Weight 7.5 lb
Box Dimensions (LxWxH) 21.5 x 9.0 x 3.5"

 

Sale

Không sẵn có

Hết hàng